Conversione tensiometri

[capatosta]

il mio msg non ha suscitato molto interesse ma può darsi che c'è qlc altro AdV con problemi simili e qndi riferisco per spirito di servizio.

Ho scritto alla Loos
Dear Sirs,
I must set the shrouds of my B25 Beneteau Platu with my tension gauge model B. The shrouds have a 5 mm diameter.
The North sail Tuning Guide specifies that the upper shrouds must have a 16 tension with a 12 to 14 knots wind, the lower a 14 tension and the headstay a 5 tension with the same kind of wind. The guide also specifies that “Measurements are done using the Loos Tension PT-2 tension gauge; and to remember that different gauges show different numbers”.
What values on my model B correspond to the 16, 14 and 5 tensions indicated on your PT 2 model?
The conversion chart you have attached is not clear to me. I don’t have enough experience to read it.

I await your kind reply. Thank you.

mi rispondono subito

Sorry, there is no direct conversion to mod.B except 16 = 20 on chart, it would be best to purchase the correct gauge.

però poichè io sono capatosta, googlo un po' e trovo sul manuale North sail per il tuning del J24 una tabella comparativa bell'e pronta che corrisponde e avvalora qlla di elaborazione Loos.

Ciao

bv[hide]
  tensi1.png (Dimensione: 38,58 KB / Download: 38) [/hide][hide]
  tensi2.png (Dimensione: 45,61 KB / Download: 34) [/hide][hide]
  tensi3.png (Dimensione: 8,59 KB / Download: 34) [/hide]