28-01-2017, 21:25
(Questo messaggio è stato modificato l'ultima volta il: 28-01-2017, 21:29 da don shimoda.)
Copia ed incolla dal manuale ( BM1 )
SETTING THE ZERO-CURRENT
If no current is flowing into or out of the battery, and yet a small residual current is shown on the display, the reading can be adjusted to zero.:
1) Ensure that no current is flowing into or out of the battery.
2)Turn off the unit.
3) With the TIME key pressed, re-apply the power.
4) Release the key. SET A is briefly displayed to show that the zero current is to be changed.
The TIME key increases the setting, and the V&A key reduces it
5) Adjust the setting until the value is shown as zero discharge.
(Note: several presses of the key are needed to change the setting by 0.1).
6) When the correct value has been set, turn off the power to the unit to save the setting.
7) Turn the power back on for normal operation.
Nel mio caso bisogna essere in due persone, per spegnere ed accendere il BMx devo aprire il fusibile di protezione che si trova nel vano batterie.
BV Saluti ad Andrea e Federica .... Grandissimi
SETTING THE ZERO-CURRENT
If no current is flowing into or out of the battery, and yet a small residual current is shown on the display, the reading can be adjusted to zero.:
1) Ensure that no current is flowing into or out of the battery.
2)Turn off the unit.
3) With the TIME key pressed, re-apply the power.
4) Release the key. SET A is briefly displayed to show that the zero current is to be changed.
The TIME key increases the setting, and the V&A key reduces it
5) Adjust the setting until the value is shown as zero discharge.
(Note: several presses of the key are needed to change the setting by 0.1).
6) When the correct value has been set, turn off the power to the unit to save the setting.
7) Turn the power back on for normal operation.
Nel mio caso bisogna essere in due persone, per spegnere ed accendere il BMx devo aprire il fusibile di protezione che si trova nel vano batterie.
BV Saluti ad Andrea e Federica .... Grandissimi
