NMEA router & app

[AndreaB72]

(06-02-2017 00:51)ste.fano Ha scritto:  Andrea che sentenza usi per ROLL e PTCH?

OpenCPN usa XDR:

XDR - Transducer Values

1 2 3 4 n
| | | | |
$--XDR,a,x.x,a,c--c, .... *hh<CR><LF>

Field Number:
1) Transducer Type
2) Measurement Data
3) Units of measurement
4) Name of transducer
x) More of the same
n) Checksum

Example:
$IIXDR,C,19.52,C,TempAir*3D
$IIXDR,P,1.02481,B,Barometer*0D

Currently, OpenCPN recognizes the following transducers:
------------------------------------------------------------------------------------------------------
Measured Value | Transducer Type | Measured Data | Unit of measure | Transducer Name
------------------------------------------------------------------------------------------------------
barometric | "P" pressure | 0.8..1.1 or 800..1100 | "B" bar | "Barometer"
air temperature| "C" temperature | 2 decimals | "C" celsius | "TempAir" or "ENV_OUTAIR_T"
pitch | "A" angle |-180..0 nose down 0..180 nose up | "D" degrees | "PTCH"
rolling | "A" angle |-180..0 L 0..180 R | "D" degrees | "ROLL"
water temp | "C" temperature | 2 decimals | "C" celsius | "ENV_WATER_T"
-----------------------------------------------------------------------------------------------------
Da qui: http://webcache.googleusercontent.com/se...=firefox-b

Uso XDR.
Nella pagina delle preferenze c'è una sezione per configurare i nomi dei sensori.

BV



Sent from my Nexus 9 using Tapatalk