16-10-2023, 14:05
(16-10-2023, 13:09)cptgood Ha scritto: Come si montano questi riduttori?
https://www.spinlock.co.uk/en-GB/uk/products/xas-base
To replace the Base
(XAS-BASE0408)
(XAS and XA models)
• Remove clutch from mounting surface
• Remove three fastening screws from side
of clutch
• Remove the port side moulding. (gently ease the
panel off using a screw driver, alternatively
remove handle pin from the port moulding with
suitable punch)
• Remove forward and rear mouldings, sliding
spring arm from the hole in the blue pivot in rear
moulding
• Remove base from mouldings
• Slide new base into forward and aft mouldings.
• Push blue pivot moulding into place – from port
side of rear moulding, ensuring spring is trapped
on spring arm
• Locate springarm in cam through hole in
port side
• Replace side moulding ensuring all parts ar e
located correctly between both side mouldings
• Replace three fastening screws
• Replace clutch on mounting surface