03-10-2011, 16:35
Citazione:Maintenance should be undertaken at least once a year all bearings should be greased with grease (Part no. 312-501), a tube of which is delivered with the mast. Read the following instructions and fig. 9:1.
Halyard swivel
Grease the bearings by pressing grease directly into the recesses #61569; and #61570; by the rotating ring. This is Best done when the swivel is opposite the sail feed inspection hole #61575;.
Seldén furling mast gear.
Remove the upper oval plastic plug #61572;.
Lift the rubber boot, and grease the upper bearing #61571; on the roller mechanism.
Remove the lower oval plastic plug level with the reefing winch and on the side of the mast. Grease the bevel gears #61573;, and the ball bearing #61574;.
All grease points are shown in fig. 9:1.
Maintenance of the Seldén
furling mast
Periodic maintenance
If the reefing system should begin to be stiff after several years usage it can be necessary to dismantle its components for servicing. Clean the gears and ball-bearings from old grease and relubricate.
The seldén furling mast is designed for easy servicing even after a long period of time. The holding
Bolts for the reefing unit are screwed into stainless steel blind nuts and are not subject to corrosion.
Dismantling is described on page 12.
