03-01-2016, 16:19
(Questo messaggio è stato modificato l'ultima volta il: 03-01-2016, 17:20 da Luciano53.)
@Flab
Da quanto ti hanno detto in Western mi sa che sbagliavo cercando di mettere il regolatore il più vicino possibile alle batterie.
Che sezione di cavo hai usato nel tratto regolatore/batterie?
PS: però la Votronic dice un'altra cosa, opposta a Western. Chi ha ragione?
----
Mounting:
Screw-down the solar controller on an even and hard mounting surface at locations being protected from humidity and
near the main/board battery (BOARD I) to ensure that the length of the battery's connection cable is as short as possible. Vertical installation of the controller is highly recommendable (the terminals for solar panel and batteries point down).
This mode of installation improves cooling of the unit and avoids that water runs along the connection cables of the solar panel into the solar controller, even in case of damaged seals.
If used, the cable to the starter battery (START II) can be longer.
Despite the solar controller's high efficiency, heat is produced. Ensure sufficient ventilation in the environment of the unit, so that the heat can be carried-off.
The unit might heat-up. Consequently, the vent holes of the casing should never be covered to ensure full charging capacity (minimum distance all around: 10 cm).
------
Nello schema che segue vengono date indicazioni per una lunghezza massima del cavo fra regolatore/batteria di 2 metri.
Da quanto ti hanno detto in Western mi sa che sbagliavo cercando di mettere il regolatore il più vicino possibile alle batterie.
Che sezione di cavo hai usato nel tratto regolatore/batterie?
PS: però la Votronic dice un'altra cosa, opposta a Western. Chi ha ragione?
----
Mounting:
Screw-down the solar controller on an even and hard mounting surface at locations being protected from humidity and
near the main/board battery (BOARD I) to ensure that the length of the battery's connection cable is as short as possible. Vertical installation of the controller is highly recommendable (the terminals for solar panel and batteries point down).
This mode of installation improves cooling of the unit and avoids that water runs along the connection cables of the solar panel into the solar controller, even in case of damaged seals.
If used, the cable to the starter battery (START II) can be longer.
Despite the solar controller's high efficiency, heat is produced. Ensure sufficient ventilation in the environment of the unit, so that the heat can be carried-off.
The unit might heat-up. Consequently, the vent holes of the casing should never be covered to ensure full charging capacity (minimum distance all around: 10 cm).
------
Nello schema che segue vengono date indicazioni per una lunghezza massima del cavo fra regolatore/batteria di 2 metri.