09-10-2017, 22:06
The cutter stay is located more than 6% of the height of the foretriangle below the
existing forestay. In this case, running backstays are necessary. The forestay fitting
should be fitted within 1000 mm of the spreaders, with the running backstays preferably
300-500 mm above. Whichever option is chosen, the amount of material cut out
from the mast may be over-concentrated in a small area. Please contact Seldén Mast
for advice on the correct fastenings and the correct location of the fastenings, as
well as the halyard control system.”
He just has to find a location that is according to that and that not cut out is closer than 350 mm from an existing cut
existing forestay. In this case, running backstays are necessary. The forestay fitting
should be fitted within 1000 mm of the spreaders, with the running backstays preferably
300-500 mm above. Whichever option is chosen, the amount of material cut out
from the mast may be over-concentrated in a small area. Please contact Seldén Mast
for advice on the correct fastenings and the correct location of the fastenings, as
well as the halyard control system.”
He just has to find a location that is according to that and that not cut out is closer than 350 mm from an existing cut