Vabbè dite pure la vostra ma almeno un po di ricerca sull'esperienza mondiale sarebbe da leggere, leggete quanto si dice qui:
What is Thread Galling?
Thread galling occurs during installation when pressure and friction cause bolt threads to seize to the threads of a nut or tapped hole. It is also known as "cold welding".
Once a fastener has seized up from galling it is typically impossible to remove without cutting the bolt or splitting the nut.
What Bolts Are Susceptible To Galling?
Galling is most often seen
in stainless steel (especially when using lock nuts), aluminum, and titanium. Fasteners with damaged threads and fine threads are particularly prone to galling. Hardened steel bolts, especially when zinc plated, rarely gall.
Immagino che un cantiere come Beneteau non faccia risparmi per 10 miseri dadi autobloccanti piuttosto non ce li mette perchè sa che poi smontarli potrebbe essere un problema e quelle misere rondelle alla fine sono efficaci. Quando non esistevano i dadi autobloccanti gli accoppiamenti si facevano lo stesso con le misere rondelle....
Questo contenuto non e' visualizzabile da te Ospite. Se vuoi vederlo, REGISTRATI QUI .